Wireless-N Outdoor AP

Hardware Specification

Physical Interface

2 x RJ-45 for 10/100 Fast Ethernet

1 x Reset Button

Power Requirements

- Active Ethernet (Power over Ethernet)

- Proprietary PoE design

- Power Adapter 24V / 0.6A

RF Specification

Frequency Band

802.11b/g/n

Data rate

300 Mbps

Radio Frequency Band

(The Max. Power may be different depending on local regulations)

Antenna

2 x External SMA Connector

Environment & Mechanical

Temperature Range

Operating -20°C~70°C

Storage -30°C to 80°C

Humidity (non-condensing)

0%~90% typical

Dimensions

186mm (L) x 100mm (W) x 29mm (H)

Weight

300g

Hardware Features

High output power

Transmit high output power programmable for different country selections

High Data Rate

High speed transmitting rate up to 300Mbps with 2T2R 802.11n

Long range transmitting

Transmit power control and distance control (ACK timeout)

Signal Strength Display

Indicate RF signal strength to be shown as LEDs of 3 colors, making network build-up easier. LED indicators have the best transmit and receive signal for traffic communication

PoE Support

Support proprietary 24V passive power over Ethernet

Software Features

Multiple SSID

4 SSID supported. Each SSID can set itself wireless or WAN access setting

PPPoE

Point-to-Point Protocol over Ethernet at Client Router mode. This function will keep trying when failed or disconnected

PPTP

Point-to-Point Tunneling Protocol (PPTP) is a method for implementing virtual private networks

VLAN Pass-through

Support VLAN Pass-through

Firmware Upgrade

Upgrading firmware via web browser, setting are reserved after upgrade

Reset & Backup

Reset to factory default. User can export all setting into a file via WEB

Ping & Trace Route

Built-in PING function & Trace Route function in Web GUI

MIB

MIB I, MIB II(RFC1213), Private MIB

SNMP

V1, V2c, V3